Mislim...hteo sam reci evo malo mnogo slicica. U nekim izdanjima ovaj mod bas simpaticno isgleda, u nekim bas i ne. Sve u svemu simpaticna gomilica 88$. Evo i malo specifikacija:
EVO Intelligent VV-LCD Transformer Kit - Dual PVThe EVO can "transform" into a multiple of configurations, a mini, a standard or a 18650 monster! Turn it into the worlds smallest incremental VV! See included pictures for the different configurations you can have with the EVOUse it as two different PV's at the same time as we include a spare standard head (do not stack batteries!)Kit Contents:1 EVO LCD Head Switch Unit, fitrs both mini and standard base1 EVO Switch (this is not warrantied, we are adding it at no extra cost)1 Battery Base (standard)1 Battery base (mini)1 Long Cover (can be used as the 18650 tube, or to cover the base or top of the PV)1 Top Cover / Extender (this part screws on the top of the EVO and twists open to different lengths to cover the atomizer/clearomizer)1 eGo Case1 IMR(ICR) 700mah 16650 battery1 IMR(ICR) 700mah 16340 battery1 Spring1 Battery Connector (for the long tube and 18650 battery)
(please note there is no charger cable in this kit, our soshine charger will charge both batteries, or you can use a standard eGo USB Charging Cable)http://www.discountvapers.com/soshine-s1-mix-v3-0-rapid-chargerThe extension sleeve is used for multiple purposes, one to cover a 510 cartomizer and also as a base that screws on to either the mini or the standard base, giving it a more finished look.The Evo's are 510 threaded and do not have eGo threads but CE4's will fit, Kanger T2's/T3's will not (you'll need an adapter)
FeaturesYou can choose to use the EVO as a mini, or a regular sized PV, or even an 18650!
- The extension sleeves can be used as a 510 cartomizer cover in any configuration or as a complete PV cover
- The Extender Sleeve can be used to cover the cartomizer or vape while protecting it (see pictures)
- Can be adjusted from 3.0~6.0 volts in 0.1 volt increments - 6AMP Limit (thery say the amp limit is higher, I have not tested this)
- Built-in two digit display allows you to visually adjust your voltage
- On/off Mode allows you to shut the unit off completely
- 10 second Cutoff cuts power if the button is held down for too long
- Reverse monitoring shuts the unit off once a battery has reached end of charge
- Amperage limiting system protects against over current situations
- Thermal monitoring shuts the device off if it detects a high temperature condition
- Reverse battery protection, output over-current protection, short circuit protection and Low quiescent current
- The special ultra-high efficiency buck-processing chip, the more effective regulation of the regulated output voltage. LCD digital power display
- Low-voltage display function
- Built with a round translucent plastic and solid tactile metal firing button, Exclusive reliable and safe electronic switch designed for long life
Please keep in mind if used as a mini the 700mah 16340 battery will not last long in higher voltages.To use the PV with an 18650 battery you must put the included spring (wider side toward the bottom) into the Long tube and pop the battery connector into the EVO-LCD head on the underside, once both are in place you add the 18650 to the long tube and screw it on to the LCD, now you have an 18650 battery! Take a spare 18650 battery and you'll never be without a backup.
User settings:How to change settings. The menu is arranged in the following order:1.Uu - Power up2.Ud - Power down3.So - Power on/off4.dS - display information setting (- “do”- atomizer output voltage -“dR” - atomizer ohm )5.Lo – Led light on/offBattery & Usage:We recommend you use IMR high drain 16650 batteries (16340 batteries for the "mini" ) This will give you the full range of voltages and the proper power needed to use the device. Unscrew the battery tube and slide the battery, positive (+) end towards the front of the unit, then screw the battery tube and take care not to over-tighten. DO NOT STACK BATTERIES IN THIS UNIT! It is not made for stacked batteries and will be dangerous to use.Charging:
The LCD EVO can be charged two ways:You can use a standard eGo USB charger to charge the device directly from the top like a standard eGo battery or remove the internal battery to charge with a seperate charger.(Chargers sold seperately)
Basic function And Display Information:Power OnThe LED light flashes 3 times when power-on reset, LCD screen on, system comes into power saving mode if not smoking in 3 seconds10 Second shut offThe LED will flash 8 times ( LCD screen display “L.on” Mode), when going er the 10 second limitSetting ModePress the button 3 times in 1.5 seconds and enter setting mode; leave the button idle for 2 seconds, system exits the setting modeautomatically.Voltage AdjustThe LCD EVO is a smart microprocessor controlled electronic cigarette that uses the latest technology to allow you to set a range of voltage.There’s no way to accidentally reset the voltage and you can make the changes within seconds.The LCD EVO allows you to digitally dial in your favorite voltage on its mini display.You can adjust the voltage from 3.1 to 6.0 using the built in user interface. Press the button 3 times rapidly to bring up the menu and select 1.Uu to change voltage higher or 2.Ud to set voltage lower. Select the high/low setting a wait one second, it will change to the current voltage reading, clikc the button to cycle through the voltages, when done,m stop the EVO will save that voltage.
Suggested atomizer or cartomizer ohms:3V-4V for 1.0-1.5ohm4V-5V for 2.0-2.5ohm5V-6V for 2.5ohm-4ohmShort Circuit ProtectThe LCD display will show the "F2" error code when output short circuit during smoking (short circuit or short atomizer). If this error appears, remove the atomizer and replace with a different one or lower your voltage settings. The LCD will automatically reset when the problem is fixed.Low Atomizer Resistance Detection AlarmWhen the resistance of the atomizer is less than 1.0 ohm, the output voltage is more than 4.5 volts, the device will alert you and button LEDflash 8 times. Locate the problem or replace the atomizer and the device will resume normal operation.Low-Voltage DetectionWhen the battery voltage is below 3.4v, The LCD will display "Lo" and battery symbol flashes indicating that your battery is low, the device will shut down to protect from over discharge. At this time recharge the battery.The LCD battery symbol shows the battery power as follows:4 Grid-------4.05V or more3 Grid-------3.9V2 Grid-------3.7V1 Grid-------3.4VBattery symbol will flash frame when battery has no powerBelow 3.4V, display battery frame will flash when press button, after 5 seconds turn off, alert you the battery have no power and need to replace the battery or charge.
DO NOT STACK Batteries! The EVO is NOT meant to be used with two batteries and it is dangerous to do so.
Korisna adresa: http://www.discountvapers.com/evo-intelligent-vv-lcd-transformer-kit/